Location:
Search - Digital Tube
Search list
Description: Digital tube display program design
Digital tube display program design
Digital tube display program design
Digital tube display program design
Digital tube display program design
Platform: |
Size: 4048 |
Author: 244626193@qq.com |
Hits:
Description: 我自己编写的74HC595数码管显示程序,一个595驱动两个共阳极数码管-I have written 74HC595 digital tube display program, a total of 595 drive two digital tube anode
Platform: |
Size: 10240 |
Author: 李康保 |
Hits:
Description: LED数码管上显示任意十六进制数字，并且利用中断直接实现扫描-LED digital tube display arbitrary hexadecimal digits, and realize the use of interrupted direct scanning
Platform: |
Size: 25600 |
Author: 张晋 |
Hits:
Description: 单片机是52的，P0口连到四个数码管的七个管脚，其中两个冒号点为最后两个数码管的DOP点，P1.0至P1.3为四个数码管的选通端，低电平有效。程序2较完整，可实现设定时间功能。-Singlechip is 52, P0 port connected to four of the seven-pin digital tube, two of which point to the last two colon tube DOP-point digital, P1.0 to P1.3 for the election of four digital tube pass-side, active-low. 2 a more complete procedure, set the time function can be realized.
Platform: |
Size: 19456 |
Author: 刘琳琅 |
Hits:
Description: 51单片机实现7段数码管显示源代码+Sch电路原理图-51 Singlechip realize 7 digital tube display source code+ Sch circuit schematic
Platform: |
Size: 579584 |
Author: 宇宙的弦 |
Hits:
Description: 使用Cypress的Cy7C68013A芯片进行设计，控制外部LED数码管的显示。程序包括USB固件程序以及主机程序-The use of Cypress s CY7C68013A chip designed to control the external LED digital tube display. This process includes the USB firmware and the host program
Platform: |
Size: 454656 |
Author: feelmen |
Hits:
Description: 用51单片机实现数字钟
利用数码管、I/O口实现数字钟的计数功能，并显示在数码管上-With 51 single-chip digital clock use of digital control, I/O port to achieve digital clock counting function, and display in the digital tube
Platform: |
Size: 9216 |
Author: winnichan |
Hits:
Description: 74ls164数码管的显示程序，程序完成的功能如下：从0显示到9
-74ls164 digital tube display procedures, procedures for the completion of the function are as follows: from 0 to 9 displayed
Platform: |
Size: 31744 |
Author: liutao |
Hits:
Description: 6位数码管显示程序，通过AT89S/C52,11.0592MHz控制，
显示非常稳定。一个符号位，
5个数据位（3整数，2小数）-6 digital tube display program, through AT89S/C52, 11.0592MHz to control, indicating very stable. A sign bit, 5 data bits (3 integers, 2 decimals)
Platform: |
Size: 1024 |
Author: |
Hits:
Description: 单片机控制时钟芯片DS1302，数码管显示程序-Single-chip microcomputer to control the clock chip DS1302, digital tube display program
Platform: |
Size: 1024 |
Author: Arthur |
Hits:
Description: STC单片机数码管测试程序，P4.0控制595时钟，P4.3控制595锁存，高有效， P4.1为LED 数据输入口-STC Single-chip digital tube test procedure, P4.0 control 595 clock, P4.3 control latch 595, high-effective, P4.1 input data for the LED
Platform: |
Size: 18432 |
Author: xiaohua |
Hits:
Description: 数码管显示的接触式交流稳压器MCU46R47-Digital tube display contact AC voltage stabilizer MCU46R47
Platform: |
Size: 6144 |
Author: 砚波 |
Hits:
Description: 数码管显示接触式交流稳压器MCU21P，非常稳定，成本低！-Digital tube display contact AC voltage stabilizer MCU21P, very stable, low cost!
Platform: |
Size: 6144 |
Author: 砚波 |
Hits:
Description: DS1302的1602时钟电路设计LED数码管时钟电路采用24h计时方式，时、分、秒用六位数码管显示，其中小时、分、秒之间用小数点分开。该电路采用AT89C52单片机和DS1302实时时钟芯片，使用5V电源进行供电，使用3个按键进行调时，调整过程中被调节的分钟或时钟将进入闪亮状态，看上去非常直观，另外，本设计还具有快速调时功能，当按键一直被按下时，便进入快速调时状态。[-DS1302 circuit design of the 1602 clock LED digital tube clock circuit 24h time mode, hour, minute, second with six digital tube display, including hours, minutes and seconds between the use of the decimal point separately. The circuit used AT89C52 MCU and DS1302 real time clock chip, the use of 5V power for electricity, the use of three buttons for transfer, the adjustment process by regulating the minutes or the clock will be flashing, and looks very intuitive, In addition, The design also features fast transfer time, when the button has been pressed, they enter a state of rapid adjusting the time. [
Platform: |
Size: 74752 |
Author: luchanggui |
Hits:
Description: 嵌入式arm7平台s3c44b0数码管显示实验，源代码完整，可直接实验移植。-S3C44B0 embedded ARM7 platform digital tube display experiment, the source code integrity, direct experimental transplantation.
Platform: |
Size: 101376 |
Author: ade |
Hits:
Description: 4位7段数码管电子钟C语言源文件，使用ICC开发，单片机为ATmega8，详细接口定义见注释-4-digit 7-segment digital tube digital clock C language source files, use the ICC development of SCM as ATmega8, detailed interface definitions, see note
Platform: |
Size: 24576 |
Author: wanghao |
Hits:
Description: 4位7段数码管的VHDL程序，6MHz晶振-4-digit 7-segment digital tube VHDL program, 6MHz Crystal
Platform: |
Size: 208896 |
Author: ye shuai |
Hits:
Description: 关于多位数大尺寸高亮度低成本LED数码管驱动电路的设计-On multi-digit low-cost large-size high-brightness LED digital tube drive circuit
Platform: |
Size: 178176 |
Author: czz |
Hits:
Description: 本程序集成中断、定时器、LED灯、数码管显示，可完成每隔100ms数码管显示的数减小1，同时以500ms的速度进行流水灯，当数码管上的数停止，实验板上流水灯也停止然后全部开始闪烁，3s后流水灯全部关闭、数码管上显示 出"8520",然后保持住-This program integrated interrupt, timer, LED lights, digital display, to be completed by every 100ms digital display reduces the number 1, while the speed of 500ms water to light, when the number of stops on the digital control experiment on-board water Then all the lights have stopped flashing, 3s after the water all the lights turned off, digital tube display " 8520" , and then hold
Platform: |
Size: 16384 |
Author: 刘朋 |
Hits:
Description: 该程序，可实现数码管的滚动显示，且程序已经过测试达到预定效果。-The program, which can realize digital tube rolling display, and the program has been tested to the expected effect
Platform: |
Size: 16384 |
Author: 周大看 |
Hits:
« 12
3
4
5
6
7
8
9
10
...
50
»